New purge says hord cannot reach coffer

Purge worked fine through 3 uses. All of a sudden says coffer in an unreachable location. Also my followers also cannot come in my base as it is also an unreachable location. Please look into this thanks. It seems that my map is a none walkable floor. Signed out and back in did not fix it.

Is your base fairly high up? Such as H-11 on Exiled Lands

I had the same issue all was working well then after adding a few bits and pieces of furniture to my base I was told the purge couldn’t put down a base. So then I had to cater to the enemy’s needs. In the end I just deleted my coffer and placed another in the exact same spot and it started to work again.

They need a clear walkeble path to the coffer, tey to remove hinders.

New purge says: hord cannot reach coffer

Me: I’m glad you finally understand ! :relieved:

They’ll be demanding snacks and warm towels next.:joy:

1 Like

the new purge is bugged…

When I tested the new purge system, I had one set of foundation blocks, one door frame, NO DOOR, no placeables in a flat area of the open desert near the King Scorpion just south of Tower of the Bats. While most purges ran as they should, several claimed that the purge could not reach it.

There is an under-lying issue in the game.

EDIT - Stairs lead directly to foundation block with open door frame.

Single 5 x 5 room.

No jumping/climbing required to get to the doorway.

No defenses/barriers inside or outside.

And you can walk the hole way whit only WSAD? no jumps? And no palisades or somthing that makes it norow, whe nwe had to many of them it dident work.

NPC need a GPS :sweat_smile: :rofl:

Ok I’m at work right now so this will be hard to explain without my computer so I’ll give it a shot.
I had the same issue so I started deleting stuff In my walkway to my coffer and what did it for me was deleting two of the tall angled pieces from the new pyramid set. I had two of the tall angled pieces facing each (angled sides facing each other) with a single foundation space gap in between __|_/|__👈like that apparently that was stopping them and after deleting the two angle pieces all is working now perhaps a collision issue for me.

I created another thread about this issue. I had to move the coffer around too many times to finally get it going.

1 Like

This topic was automatically closed 7 days after the last reply. New replies are no longer allowed.